Gateway DC-M50 Bedienungsanleitung PDF herunterladen (Seite 163)

163

Solution

Rotate the function dial to and slide the power

switch to turn on the camera.

Replace all four batteries.

Remove the batteries and then insert the batteries by

following the +/- diagram indicated on the front of the

battery-chamber door.

When "NO CARD" is displayed on the LCD monitor and

"CF" is displayed on the data panel, the CF card is not

set. Insert the CF card.

Slide the power switch to turn on the camera again.

The camera reads out the image data from the CF

card.

Wait until the reading is completed and the focus lamp

and "PLAY BACK" stop blinking.

Take a picture within the flash range ( 15 to 118 inches)

( 40 to 300 cm ).

Problem

The image

cannot be

played

back on

the LCD

monitor.

The image

recorded in

the flash

mode is

dark.

Check

Is the camera turned off?

Are the batteries exhausted?

Are the batteries inserted with the

correct polarity?

Is the CF card inserted in the

camera? ( Is "NO CARD"

displayed on the LCD monitor? )

The auto power off function

activates.

Is the focus lamp ( green )

blinking slowly (about 2 times in

a second ) and "PLAY BACK"

blinking on the LCD monitor?

Did you take a picture within

the flash range?

Page

1 2 ... 158 159 160 161 162 163 164 165 166 167 168 ... 173 174

Kommentare zu diesen Handbüchern

Keine Kommentare

Gateway DC-M50 Bedienungsanleitung Seite 163

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Kameras Gateway DC-M50