Gateway 9715 Bedienungsanleitung PDF herunterladen (Seite 122)

117

www.gateway.com

Processors

10 Place the heat sink on the processor, making sure the thermal grease is applied

correctly or the Thermal Interface Material (TIM) is aligned between the heat sink and

the processor.

11 Line up the four captive screws with the four posts surrounding the processor, then

gradually and evenly tighten the four captive screws to secure the heat sink to the

system board (see “Torque settings” on page 64).

12 Install VRMs as necessary (see “Processor VRM requirements” on page 118 and

“Installing and removing VRMs” on page 118).

13 Replace the processor air baffle by following the instructions in “Removing and

installing the processor air baffle” on page 67.

14 Follow the instructions in “Closing the server case” on page 72.

Caution

Failure to apply the Thermal Interface Material or thermal grease

between the processor and the heat sink could result in damage to

the processor and the server.

8510702.book Page 117 Thursday, July 7, 2005 11:21 AM

1 2 ... 117 118 119 120 121 122 123 124 125 126 127 ... 277 278

Keine Kommentare

Gateway 9715 Bedienungsanleitung Seite 122